5 Station unwind and single station powered rewind
Hinged one side for easy access to internal rolls
500 lb. cap.Ea. unwind or rewind
3” core inserts o… More info
This Hitch Feed is designed to attach to a Hitch Feed Press. The system is a Servo conveyor belt, and the input side and the output side run in unison.
The material is clamped to the belt while it… More info
This press has a reciprocating belt that is die cut on. It is variable frequency drive that controls the movement of the belt. The input side has a clamp that holds material to the belt so multiple l… More info
Unwind one feeds straight into machine while unwind two feeds in 90 degrees from unwind one. The webs are set up to run through an automatic splice station that allows the operator to tag on the next… More info
This laminator is a protective film laminator that automatically sets the gap between sheets and hot wire cutoff between the gap. This laminator also had an optional reject sheet conveyor. More info
The cross cutter is designed as a free standing unit that can monitor an incoming web of material and cut it off at a preset length. The unit will be controlled by an AB PLC. It will receive speed … More info
Designed for high speed continuous 24 hour, 7 days a week operation.
Processes rolls of material into sheets at up to 1,000 ft/min depending on material.
Rotary single or dual knife fixed-bed cutter … More info
Servo drive operation.
Speeds up to 300 feet per minute depending on increment length.
Increments as small as 1/4”, up to 120”.
Tolerance of +/- .015”.
Down-acting scisso… More info
Servo drive with operator display
Programmable speed with acceleration/deceleration selects
Heavy duty down acting scissor shear cutting blades
Interface… More info
Omega Ultra Press Overview
Hydraulic Power Unit
The hydraulic system incorporates an electronically controlled variable displacement pump to generate hydraulic power. Valves direct and control hydr… More info
Rotary Die Cutter with dual turret unwind, feeding one roll at a time. Inline heated splice station. The web is fed into the rotary die cutter. There are three components to this die cut operation.
… More info
The objective of the machine is to apply corrugated material to the full length of a garage door panel, then deliver panel for further processing. To do this, the system is composed of an Entry Nip S… More info
Slitter Rewinder with 20 rewind diameter capacity. The system will use an unwind stand (see Unwind specification), and Tidland Class II E-Series Shear Slitting.
Tension controls managing the Drive… More info
Efficiency and ease- of-operating define the Carousel Unwind Dancer. This machine runs individual Prestige rolls through a time-powered unwind that dispenses material to the sheeting unit. When the c… More info
Cantilevered Unwind with Web guide Maximum weight 1150 lbs (515kg)
6” Air shaft
Maximum diameter: 33.5” (850mm) Maximum web width: 40” (1000mm) Minimum web wid… More info